Skip to content

Cart

Your cart is empty

Continue shopping

Knowledge

PMOLED Display ODM Supplier | Custom Outline, FPC Routing, Sample Validation
Aug 5, 2026
PMOLED Display ODM Supplier | Custom Outline, FPC Routing, Sample Validation

Approve a PMOLED ODM supplier only after the module fits the real enclosure, reaches the production connector without FPC stress, runs with the final.

Custom Graphic OLED Module Manufacturer | Controller EOL, FPC Pinout, Firmware Migration
Aug 5, 2026
Custom Graphic OLED Module Manufacturer | Controller EOL, FPC Pinout, Firmware Migration

Yes, an obsolete graphic OLED module can often be replaced without changing the enclosure or host PCB. The replacement must keep the required outline.

Why Does an I2C OLED Stop Responding After Repeated Sleep Cycles?
Jul 31, 2026
Why Does an I2C OLED Stop Responding After Repeated Sleep Cycles?

An I2C OLED usually stops responding after repeated sleep cycles because one sleep or wake event leaves the bus, MCU peripheral, GPIO pins or OLED.

Why Does a PMOLED Display Have Uneven Brightness Between Rows?
Jul 31, 2026
Why Does a PMOLED Display Have Uneven Brightness Between Rows?

A PMOLED display has uneven row brightness when one physical row receives less current, less effective lighting time, or more voltage loss than the other.

Why Does a TFT LCD Reset When the Backlight Brightness Is Increased?
Jul 31, 2026
Why Does a TFT LCD Reset When the Backlight Brightness Is Increased?

A TFT LCD usually resets when brightness is increased because the backlight draws more power and causes the supply voltage to drop. Other possible causes.

How to Use the MIPI DSI TE Signal to Prevent Screen Tearing
Jul 24, 2026
How to Use the MIPI DSI TE Signal to Prevent Screen Tearing

Use the panel’s TE signal as the trigger for command-mode screen updates. Prepare the image, cache work, commands, and DMA before the TE edge arrives.

ePaper BUSY Pin Timeout | Causes, Troubleshooting, and Firmware Recovery
Jul 24, 2026
ePaper BUSY Pin Timeout | Causes, Troubleshooting, and Firmware Recovery

Quick answer: An ePaper BUSY pin timeout means the firmware waited for the display controller to finish an operation, but the expected idle level was not.

Exit Pupil and Eye Relief Explained for Micro OLED Near-Eye Displays
Jul 24, 2026
Exit Pupil and Eye Relief Explained for Micro OLED Near-Eye Displays

Exit pupil controls where the eye must be placed, eye relief controls how far the eye sits from the optics, and the eyebox shows how much movement the.

MIPI DSI Black Screen Debugging | Power, Reset, Lane Mapping, and DCS Commands
Jul 17, 2026
MIPI DSI Black Screen Debugging | Power, Reset, Lane Mapping, and DCS Commands

A MIPI DSI black screen usually comes from one of four places: Light output: an LCD backlight is off, or an OLED panel is not emitting light. Panel state.